Let There Be (More) Light

A few years ago, I decided my front walk area was too dark at night, so I replaced a non-functional gas post light with a solar LED fixture that fit on the gas light's post. Equipped with a simple photocell, it turned itself on at dusk and usually remained on until the battery ran down, putting out enough light to be ornamental but not enough to make a functional difference. The fixture was fairly expensive and the internal battery, which was charged by the solar panel on top, only lasted a short time before it would no longer take a charge. Replacements were expensive and hard to find.

In time, I decided I needed something more practical, so I got a couple of motion activated, solar powered LED floodlights, which helped greatly; however, because of their placement between the two front windows, the ends of the walkway were still in relative shadow. 

For whatever reason, most likely laziness, that remained the status quo for several years, but as one light has grown noticeably dimmer over they years, I finally decided more light was needed, so I ordered two more solar lights of a similar design. 

The new lights arrived yesterday and I promptly installed them. Even with a proper masonry bit, drilling holes in bricks is no easy task, but now that they're up, the walkway is without shadow from end to end. The new fixtures are not identical to the old ones; they actually offer more illumination with their 144 smaller LED's versus the old ones' 20 larger LED's. While the older ones have their LED's only on the front, the newer ones have them on the front and sides, offering a wider spread of illumination. 

Perhaps the biggest difference is the presence of a push-button switch on the front of the new ones, which toggles between four operational modes--constantly on (dim), dim/bright (contstantly on dim, automatically going to full brightness when motion is detected), (off/bright) (off until motion is detected, then to full brightness), and completely off. I'm using the off/bright mode to mirror the operation of the older ones, which have no switch and are simply motion activated. 

The beauty of these motion activated lights is that they are only on for less than a minute at a time, providing light only when it is truly needed. This means the internal storage batteries are never fully depleted. Also, each one costs about the same as a conventional floodlight bulb and they require no wiring. They are completely self-contained and are ready for service almost as soon as they are mounted. A simple, practical and cost-effective solution, these lights are an excellent value, well suited for the needs of renters and home owners alike.